Old 04-13-2013, 12:07 PM
artara74 artara74 is offline
Junior Member
Join Date: Apr 2013
Posts: 1
Default Head phone repair bass problem


I have a T-jays three IEM and it was really awesome until I had some sound disconnecting in the left ear bud.

so I opened it to repair it (there s no support in my country). when I was soldering the wires the magnet on the back got the soldering iron and the silver thing on the back of the magnet area burned and a hole appeared.

so now I know I should cover the hole to have a good sound. if I leave it uncovered its bass will be so unnormal and high. I tried to cover it with A tape but after it all the bass was gone (it was so hard). so how can I find the right thing to cover it?

this is a picture of it:
Reply With Quote

Advertisement [Remove Advertisement]

Old 04-13-2013, 01:06 PM
Syndrome's Avatar
Syndrome Syndrome is offline
Redneck Moderator
Join Date: Dec 2007
Posts: 1,278

you could try gluing a piece of paper down over it, or possibly plastic. You will want to cut it small enough to fit over the white area and apply a small amount of glue. Don't use to much or it will go into the hole and possibly cause more problems.

Ruger M77 , Howa 1500 , Czech Republic 452-2E
Ruger .22 Single Six, Springfield Armory XD-9 , Springfield Armory XD45ACP
2007 Elite Archery Synergy

Gamo CFX, Gamo PT80
Large Rock

Need your headphones fixed or something soldered? Syndrome's Soldering Service
Reply With Quote


Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

All times are GMT -5. The time now is 01:18 PM.