Prev Previous Post   Next Post Next
Old 10-04-2014, 10:38 PM
Clipman's Avatar
Clipman Clipman is offline
Join Date: Aug 2008
Location: Kentucky. USA.
Posts: 169

What happened is, after the FW upgrade, when it boots for the first time, you get the touch-screen calibration screen- which is what it sounds like you are looking at. If you touch the little white square on your X9's screen, another will appear in another corner, and so forth- until all four corners have been done...then it should boot-up normally (Disconnect it from your 'puter before doing the calibration).

If it truly needs a reset, you can do so by holding down both sides of the volume-control button (the - and + ) at the same time for a few seconds.

Hope this helps.....
The world's foremost expert....on my own opinion!
Reply With Quote


Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

All times are GMT -5. The time now is 12:20 PM.