Prev Previous Post   Next Post Next
Old 07-25-2013, 04:28 PM
Lorenz092 Lorenz092 is offline
Join Date: Jan 2011
Location: Italy
Posts: 449

Originally Posted by ciccius92 View Post
Hello lebellium,
thanks for your job. I would like to ask you something. I opened a micro usb cable and i found the 5 pins...where have i to solder the resistors? A side on the unplugged pin (it should be the 4) and the other side on the pin of black wire? I can't understand if i have to disconnect the back wire and leave only the side of resistor on that pin, or i have to solder both (the black wire and the side of resistor) on pin 5. I hope you understand my question, help me please
It's very simple: you just need to place the resistor between 5th pin AND black, so that the controller chip can measure resistance with respect to ground
Wait, I'll also remind this post:
So, a 301 KOhm resistor does the trick!
Hope it's clear, otherwise just ask again...
Check out my modded firmware both for YP-R0 and YP-R1!!!
** DONATE ** ->
NOTE: if you want to donate for Rockbox itself and not my work, go to their website!!
Reply With Quote


r0, recovery tool, samsung, yp-r0

Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

All times are GMT -5. The time now is 02:06 PM.