|
#1
|
|||
|
|||
|
I have search Hi and Low for a NEW battery for my Zen Vision W.
Anyone know if you can buy a Creative Vision Battery CPA-BA0002 and remove the four screws and install it on the Vision W back cover? There seems to be all kinds of CPA-BA0002 available but they only have 4 latching slots and the W has 6 slots for the connection???? Or do you know where you can buy a W battery all the sites listing them say "out of stock" and I have been to at least 50. |
|
|
|||
|
|
|
#2
|
|||
|
|||
|
I was told by a supplier that you can remove the battery from a Creative Zen Vision back plate by removing the four screws and carefully reattach it to a Vision W back Plate the same way...Does anyone know for sure if this will work. There are lots of Creative Vision (no w) batteries for sale.
|
|
#3
|
|||
|
|||
|
Nekazoo,
There's a similar thread: http://anythingbutipod.com/forum/sho...t=32626&page=2 I used a battery for a Creative Zen Vision. Had to make two additional holes in the new battery. Been more than a year. Still works, though the battery is starting to act up now. I plan to redo it; hopefully batteries for Creative Zen Vision is still available. Hope this helps. |
|
#4
|
|||
|
|||
|
Dont Do IT! Do not cut your plastic housings!
Buy a Zen Vision battery. Take it out of the housing and replace the battery with your Vision W. If anybody needs instructions I can send them to you. If I could figure out how to post photos I would put them up for you. The moderator should leave this post up because hundreds of people are in the same boat. |
|
#5
|
|||
|
|||
|
email to nekazoo********* Thanks
|
|
#6
|
|||
|
|||
|
When you email me, please be sure to give me your email so that I can attach the photos with the instructions.
|
![]() |
«
Previous Thread
|
Next Thread
»
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
All times are GMT -5. The time now is 07:34 PM.











Linear Mode
