android
  #1  
Old 01-18-2011, 03:03 PM
ZenVisionM ZenVisionM is offline
Junior Member
 
Join Date: Jan 2011
Posts: 1
Default Any way to upload new firmware with a dead battery?

Hi everyone,

I'm stuck with the common problem that I have replaced my Zen's battery with a newer model, and it is not compatible with the newer firmware on the Zen. I have located the 1.14.01 firmware updater, but it refuses to work because "the battery is too low." So I can't switch to the older firmware that would successfully charge my battery...

Is there any known way around this problem? I am just about out of ideas. I might try swapping the old battery back in but it was extremely dead and I'm not sure I'd get different results.

A different way to upload firmware? A way to tell the updater to ignore its complaints and go ahead?

Thanks,
ZVM owner
Reply With Quote

Advertisement [Remove Advertisement]

  #2  
Old 01-18-2011, 08:52 PM
delaware74b's Avatar
delaware74b delaware74b is offline
Junior Member
 
Join Date: Dec 2007
Location: Delaware
Posts: 51
Default

Read post #41 in the following link. It discusses how to swap the battery monitoring 'chip' from the old battery to the new, higher capacity battery. I haven't done it, but I'll do it when my battery dies (still getting 5 hours of music playback with no display). The OEM batteries are VERY scarce.

http://www.anythingbutipod.com/forum...t=34551&page=3

I hope it helps.
__________________
Zen Vision:M 30GB
Reply With Quote

Reply

Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump



All times are GMT -5. The time now is 05:12 PM.